Hello Guest it is March 28, 2024, 06:06:21 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - cooter

Pages: 1
1
General Mach Discussion / Re: Z-Axis Height Between Parts
« on: October 18, 2015, 06:14:49 PM »
Awesome, I'll give that a shot!

2
General Mach Discussion / Z-Axis Height Between Parts
« on: October 18, 2015, 03:01:33 PM »
Hello,

New member, fairly new to mach. Anyway, I am using Mach3 to run a plasma table and Sheetcam to generate my gcode. On thing that I have been unable to figure out is how to set the z-axis (torch height) between parts. If I have multiple parts (or times when the torch stops and moves before restarting) I would like to increase the height when it moves between cuts.

Can anyone tell me where I can set this? Is it in Mach or Sheetcam?

Thanks!

Pages: 1