Messages

1

PoKeys / Re: Pokeys57CNC Mach3 connect 2 drivers on same Axis

« on: May 14, 2016, 03:28:36 AM »

Hi NeoTo,

Thank for you reply.

I have two supplementary questions.
  - In the case of connecting to the same connectors, the current absorbed by the 2M452 2 drivers, not going to damage my card pokeys57cnc
  - In the case of master / slave assembly, Pokeys configuration software, does not know this type of installation. How to configure the second axis for homing?

2

PoKeys / Pokeys57CNC Mach3 connect 2 drivers on same Axis

« on: May 13, 2016, 06:59:12 AM »

Hi,
I need to connect 2 motors in the X How to connect my 2 drivers on my Pokeys57CNC card, and how to configure for homing function.
Thank you for your reply.

3

PoKeys / Re: Pokeys57CNC switch pin Mach3

« on: October 24, 2015, 02:16:08 AM »

For the Z axis : Step = 160.2605863  velocity : 3000 and acc : 496.06707

The command is in MDI : G31 Z-100

The version of Mach3 is the latest an licenced, idem for Pokeys , the version of software is 3.1.65 and firmware 4.1.41

4

PoKeys / Re: Pokeys57CNC switch pin Mach3

« on: October 23, 2015, 09:24:25 AM »

When y try to invert the probe signal, i get the message: Probe Ignore. actived at call for probe.
where find the motion parameter ?

5

PoKeys / Re: Pokeys57CNC switch pin Mach3

« on: October 23, 2015, 06:14:30 AM »

- When I increase the homing speed on the X and Y axes, I exceed the home switch and stop the limit switch.
- The G31 command forwarding me the error: Probe error - overrun

6

PoKeys / Re: Pokeys57CNC switch pin Mach3

« on: October 21, 2015, 04:07:16 AM »

Hi NeoTo,

Thanks for your answer.
I had not selected the pin 0 on 3 axes in Pokeys configuration software, homing working properly but with a very basic speed.
I always have trouble with probing, the switch probe is well recognized in Mach3. Digitalize the led shows the manual activity on the switch probe, but the command GCODE G31 Z-50 has no effect on the Z axis, the axis does not move.
Is there another command to perform the probing?

7

PoKeys / Pokeys57CNC switch pin Mach3

« on: October 16, 2015, 08:06:01 AM »

Hi,
I use Mach3 an Pokeys57CNC.
 I can not find the link between the SWITCH pin connector and pin number configuration. What should I set pin using the Swicth card connector.

Thanks for your help