1
Mach4 General Discussion / Re: Mach4 Printer Port Discussions
« on: October 13, 2015, 04:02:35 PM »
Art,
Not sure if that reply was for me, but I did have to increase step pulse to 5us in Mach3 before I could get it to smooth out. I couldn't figure out where to change that parameter though.
-Jason
Not sure if that reply was for me, but I did have to increase step pulse to 5us in Mach3 before I could get it to smooth out. I couldn't figure out where to change that parameter though.
-Jason