Hello Guest it is March 28, 2024, 01:18:44 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - rayco

Pages: 1
1
General Mach Discussion / Re: problem with Z axis
« on: October 15, 2015, 05:58:00 PM »
thanks

2
General Mach Discussion / Re: problem with Z axis
« on: October 15, 2015, 05:53:19 PM »
I work with Lazycam, I have my feedrate and cutter speed, that's ok.

3
General Mach Discussion / Re: problem with Z axis
« on: October 15, 2015, 05:05:35 PM »
Now another question: how do I put the tickness of the material I put on the table to be cut? If I want to cut 3/16" polycarbonate... how and where? I learned the rest, how to make G-code, it's working very well....

4
General Mach Discussion / Re: problem with Z axis
« on: October 15, 2015, 05:03:41 PM »
Ok Robertspark, the reason is it is because I don't know anything about CNC, I'm learning from scratch and from videos I find on Youtube... thanks for the trick "Config >>> Pins and ports >>> Motor Outputs >>>> and flip / switch the "Dir LowActive"  setting / state the opposite direction" it was so simple! It works like magic

5
General Mach Discussion / problem with Z axis
« on: October 11, 2015, 03:29:57 PM »
Hi I'm new here and I'm trying to learn how to use my GreenBull 5x10 CNC machine. I speach french (Quebec, Canada), I'll try to do my best in english. I saw a lot of Youtube videos, ans I'm almost ready to cut. But I have problems with the Z axis. I set the motor tuning (usually it gives me 6400) but almost each time I try to run a G-code, when the tool go up, no problem, but when it goes down, it's always too much. So it goes 1/4" up, go down 1/2", goes up 1/4", goes down 1/2"... not exactly that, but it gives an idea...

When the table was assembled, X and Y axis were perfect, but the Z axis was working the reverse way, so when nI was pushing the Z+ button, it was going down. I took the motor and turned it upside down. Someone can help me please? I have a big contract soon and I need it!

Pages: 1