Hello Guest it is April 10, 2021, 11:24:25 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - 2katia2

Pages: 1
1
General Mach Discussion / Re: DDSM3_V5.0 (USB controller)
« on: October 16, 2015, 02:24:26 PM »
What is your opinion on USS (USB SmoothStepper)?

http://www.warp9td.com/index.php/products

2
General Mach Discussion / Re: DDSM3_V5.0 (USB controller)
« on: October 13, 2015, 03:04:50 PM »
Thanks Tweakie.
Where can I buy it in USA?

3
General Mach Discussion / Re: DDSM3_V5.0 (USB controller)
« on: October 11, 2015, 02:54:00 PM »
Could you please advise me on 4-Axis USB MACH3 Motion Controller, which includes good technical backup services ?

4
General Mach Discussion / Re: DDSM3_V5.0 (USB controller)
« on: October 06, 2015, 06:30:32 AM »
I wrote to the factory, but they are Chinese without technical support.
Just a salesperson who's trying to help me.

5
General Mach Discussion / Re: DDSM3_V5.0 (USB controller)
« on: October 04, 2015, 11:52:37 AM »
Is there any another driver, in addition to "DDREAM_D-DDREAM-Plugln-Ver-2-0a"
that I can try to use it, instead of the "DDREAM_D-DDREAM-Plugln-Ver-2-0a"?

6
General Mach Discussion / DDSM3_V5.0 (USB controller)
« on: October 02, 2015, 12:49:01 PM »
My Controller is DDSM3_V5.0 (USB controller).

When I'm using: No Device or Normal printer port operation, Mach3 works perfect.
When I'm using: DDREAM_D-DDREAM-Plugln-Ver-2-0a ( the USB driver)
     1.   I cannot jog with keyboard and even with mouse (after I open jog panel with TAB key)
     2.   When I run G-code nothing happen.

I tried it on win7 computer and different win8 computer
I re-installed mach3, I uninstalled driver and installed again, I disabled the network adapter.
Still no results.
It worked great till 3 days ago.

Pages: 1