1
General Mach Discussion / Re: X Axis Scaling Problem
« on: October 03, 2015, 05:24:20 PM »
Rich,
Finally found the X axis flexible motor coupling although tight didn't fit the ballscrew properly. When driving +x it wrapped the coupler tighter and gripped pretty good. When moving -x it tended to unwrap the coupler and slipped a bit. Only found that when I decided to swap the X and Y motors to see if that was the problem.
Finally found the X axis flexible motor coupling although tight didn't fit the ballscrew properly. When driving +x it wrapped the coupler tighter and gripped pretty good. When moving -x it tended to unwrap the coupler and slipped a bit. Only found that when I decided to swap the X and Y motors to see if that was the problem.