Messages

1

General Mach Discussion / Re: Mach 3 demo prg

« on: September 29, 2015, 12:09:09 PM »

Thanks for that Gerry
My problem now appears to be with the parrell port not communicating with the  Breakout board  the stepper motor is all wired correct .
Using Windows XP on a tower  the software is loaded the drivers are ok and the axis movement records on  X  Y  Z
Many thanks for your help to date
Mick Magnum

2

General Mach Discussion / Mach 3 demo prg

« on: September 27, 2015, 11:44:07 AM »

Hello all
 Will the demo prg allow you to run a machine albeit restricted
Mick