Hello Guest it is March 19, 2024, 01:41:48 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - gabedrummin

Pages: 1 2 3 4 5 6 7 8 9 10 11 12 »
1
Mach4 General Discussion / Re: Upgrade problem - 4498 to 5310
« on: February 13, 2024, 12:51:08 PM »
I have had this issuewhen updating to newer version of Mach4  .In my case it had to do with my custom Lathe  screen .I copied the turn cycles from a new version on Mach4 and importred them into  my old screen and all was good .

2
Mach4 General Discussion / Re: Mach4 Pokeys57CNC interaction issues
« on: January 18, 2024, 07:36:23 AM »
Your using a pokeys motion controller. What break out board are you using with it? If its a pokeys device the manuals on their site .

3
Mach4 General Discussion / Re: Mach4 Pokeys57CNC interaction issues
« on: January 17, 2024, 01:23:24 PM »
You have to define the inputs in both Pokeys and mach software .For me the problem is trying to figure out which pokeys pin its connected to .Then you need add script ( edit screen /start macro) so Mach knows what to do once you trigger that input .

4
Mach4 General Discussion / Re: mini pc
« on: December 08, 2023, 01:46:44 PM »
I use an Intell nuc.

5
Mach4 General Discussion / Re: Turret lathe axis question
« on: October 13, 2023, 03:27:25 PM »
What are you trying to offset ? The turrets rotation or a tools position ?

6
Bargain Basement / Re: HiCON Integra Controller 7766
« on: September 18, 2023, 03:14:49 PM »
Is this the open or closed loop system?

7
Bargain Basement / Re: HiCON Integra Controller 7766
« on: September 18, 2023, 01:14:04 PM »
Did this sell ?

8
Mach4 General Discussion / Re: MACH4 LATHE
« on: May 04, 2023, 02:18:18 PM »
I copied the tab from mill and inserted into my Lathe screen set.

9
PoKeys / POKEYS 57 FROM CNC4PC
« on: March 14, 2023, 10:44:33 AM »
I have two 57 ethernet core boards with pins that are missing all the screen printing dose anyone else see this issue ?

10
To use spindle as axis you have to control it with step a direction and that is the problem . The motion dose not support this.

Pages: 1 2 3 4 5 6 7 8 9 10 11 12 »