Hello Guest it is April 17, 2021, 10:07:47 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - wmcook

Pages: 1
1
Mach3 and G-Rex / Re: Need help configuring G-Rex pins in Mach3
« on: September 09, 2007, 10:12:59 PM »
Thanks for the info Brett.
It's just what I needed.

Bill

2
Mach3 and G-Rex / Re: Need help configuring G-Rex pins in Mach3
« on: September 09, 2007, 12:39:42 PM »
Thanks Brett.

Anything you can find would be a big help.

Bill

3
Mach3 and G-Rex / Need help configuring G-Rex pins in Mach3
« on: September 09, 2007, 01:04:09 AM »
Can't find instructions for configuring the pin's for G-Rex.
Can someone direct me to where the info is?

Thanks

Bill

4
General Mach Discussion / Re: Serial Interface Question
« on: June 22, 2007, 10:29:44 AM »
Kris,
Thanks for the reply. I will try your suggestions this weekend.
Bill

5
General Mach Discussion / Serial Interface Question
« on: June 18, 2007, 11:36:24 PM »
I just purchased a Phoenix GS Mill. X, Y & Z all appear to work fine with onboard controls.

Question is: System controls connect to the PC through a DB25 serial connection. Does Mach 3 support serial connection or just parallel?
It appears that the steppers are controlled with drives from centroid but not sure.

Any help or suggestions would be appreciated.

Thanks ???

Pages: 1