Hello Guest it is January 29, 2023, 11:55:35 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Belindamax

Pages: 1
G-Code, CAD, and CAM discussions /
« on: September 03, 2015, 06:23:13 AM »
Thanks for your reply I have successfully managed this though decided not to reinvent the system lol and use left front as X0,Y0 and I have been playing with the machine but now it has decided to do as asked half way through a design then skip to the right by 20 mm and carry on is it my fault or something loose?

Sent from my GT-I9195 using Tapatalk

General Mach Discussion /
« on: August 31, 2015, 06:00:16 AM »
Go to config and homing/limits there is a tick or cross against reversed  change it to opposite to what you have set this will probably sort it out

Sent from my GT-I9195 using Tapatalk

General Mach Discussion /
« on: August 27, 2015, 04:15:18 AM »
Hi I am new to this but had a similar problem and my nut at the end on the stepper motor was loose I took Allen key tightened it and everything works well now might be worth a shot

Sent from my GT-I9195 using Tapatalk

G-Code, CAD, and CAM discussions / Very new - Blonde Moment?
« on: August 26, 2015, 10:28:39 AM »
I have recently purchased a CNC router H84 and I am completely new to all of this but I am not new to industrial embroidery and this is where my question comes from
When I design something on the embroidery software I always put automatic start and end in the center of the design so when I load the file on to the machine it knows where I want to start and end and I can line up the needle and fabric - no nasty surprises machine doesn't shoot off somewhere unexpected
I don't seem to be able to get my head around this concept on the router, can I tell the machine the centre coordinates and keep them registered as the home origin so every time I start up the machine it goes straight there? i.e. X200 Y200  or do I have to set it up every time myself and physically move the spindle
or am I just having a blonde moment? or do I set it up on the design before sending to the machine if so I am using VCarve how do I do this?
Please help

Pages: 1