Messages

1

General Mach Discussion / Re: axis feeds oppisite direction after 2nd or third home

« on: August 26, 2015, 07:07:24 AM »

thanks will give that a try.

2

General Mach Discussion / axis feeds oppisite direction after 2nd or third home

« on: August 26, 2015, 06:31:01 AM »

hi,

Something that has me a bit confused, my machine will home just fine a few times and next minute it will home to the limit switch then just run back to the opposite side of the machine, I then have to restart the controller and program and rehome in order to continue use, any ideas what could be causing this issue.