Hello Guest it is March 28, 2024, 07:37:28 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - kevinjantzen

Pages: 1
1
General Mach Discussion / Help required
« on: August 21, 2015, 04:22:56 AM »
A long shot & short notice but needing help.  I have just built a 4 spindle routing machine for a friend of mine , I need to set up the machine to run his products IE. putting square holes in long square plastic tubes , I am short of time to learn the mach3 software as I want to deliver the machine to him next week.  Is there anybody local to me ( Wigan , WN22BG , United Kingdom) who would be prepared to visit my Unit  &  fast track me through the software to get the machine going , obviously I would pay for the work done. Many thanks looking forward to replies , Kevin , mob  07881523083

Pages: 1