Messages

1

Mach3 and G-Rex / Re: Soft Limits

« on: June 21, 2007, 01:54:41 PM »

Thanks Brett. Here is 1000-PLASMA.xml. Joe

2

Mach3 and G-Rex / Re: Soft Limits

« on: June 20, 2007, 02:30:45 PM »

Brett, here is .xml file as copied...Joe

3

Mach3 and G-Rex / Re: Soft Limits

« on: June 19, 2007, 10:02:53 PM »

Here's the other one....Sorry but I had to copy the file to my jump drive to bring it over from the computer that is not on line. Can't attach it directly to this post. Joe

4

Mach3 and G-Rex / Re: Soft Limits

« on: June 19, 2007, 07:42:02 PM »

Okie Dokie

5

Mach3 and G-Rex / Re: Soft Limits

« on: June 19, 2007, 06:33:09 PM »

Let me try again.....Brett, do you want me to post the entire .xml file here?  Joe

6

Mach3 and G-Rex / Re: Soft Limits

« on: June 19, 2007, 02:28:31 PM »

Let me be clear.....you want me to post the entire .xml file here?

7

Mach3 and G-Rex / Re: Soft Limits

« on: June 19, 2007, 09:55:35 AM »

No Brett, sorry, I use two computers; this one for Corel, CAD and SheetCam is connected to the net; the second has Mach3 and is *not* connected to the net (yet). Joe

8

Mach3 and G-Rex / Re: Soft Limits

« on: June 19, 2007, 09:40:55 AM »

Sorry, what is G-100? My controller is MP1000-THC.

9

Forum suggestions and report forum problems. / Soft Limit

« on: June 18, 2007, 07:12:30 PM »

I have Mach 3 configured for plasma on a DynaCNC table. The Soft Limit On/Off switch indicator flashes red when clicked on. Is this normal? Joe

10

Mach3 and G-Rex / Soft Limits

« on: June 18, 2007, 06:58:24 PM »

I have Mach 3 configured for plasma torch on a DynaCNC table. Is it normal for the Soft Limits On/Off Indicator to blink red when turned on?
Joe