Messages

1

General Mach Discussion / Re: Mach3 will not load file

« on: August 14, 2015, 11:33:50 PM »

I did both of those and it didn't work.  It downloads the file but doesn't show up on display.

2

General Mach Discussion / Re: Mach3 will not load file

« on: August 14, 2015, 02:54:56 PM »

What should the toolpath coordinates be?

3

General Mach Discussion / Re: Mach3 will not load file

« on: August 14, 2015, 02:48:03 PM »

No error msg.

4

General Mach Discussion / Mach3 will not load file

« on: August 14, 2015, 10:12:17 AM »

Newbie here, just got a 3040T with mach3. Mach3 would not install on my comp so i copied the Mach3 setup to my hard drive and then installed mach3. The problem is when I load a file to demo it doesn't show a pic on the job display, the file reads it is there but no display.
Am I supposed to buy a license? What am I missing? Thanks so much