Hello Guest it is January 26, 2020, 03:37:44 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - smr14

Pages: 1
1
Promote and discuss your product / new guide
« on: August 30, 2007, 07:18:16 PM »
Hello all....

Well I recently completed a guide for integrating the Sound Logic break out board with Glentek Inc. products. This guide has information about stepper versus servo motors as well as advantages and disadvantages of brushless versus brush-type motors. This guide is meant to assist people in learning more about servo motors and drives. I would encourage you to look at this guide. Also this talks about how Glentek Inc. products can be integrated with Artsoft Software. Hope this guide answers some of your questions. If you have any questions feel free to let me know....

Thanks,
Rick

link to guide:
http://glentek.com/newprod.html

2
G-Code, CAD, and CAM discussions / Re: Help writing G-Code
« on: June 19, 2007, 03:57:33 PM »
well according to the sound logic breakout board I am using they say to use mach 2. I tried to use mach 3 and I couldn't get it to work but I didn't try too hard because the instructions said to use mach 2

3
G-Code, CAD, and CAM discussions / Re: Help writing G-Code
« on: June 19, 2007, 03:00:26 PM »
how do you change it in mach 3....i maybe able to figure it out and translate it to mach 2 from mach 3...

4
G-Code, CAD, and CAM discussions / Re: Help writing G-Code
« on: June 19, 2007, 02:35:46 PM »
Is there anyway to make the motor run at a higher rpm, or is there a safety setting in this mach 2 programming? If you could let me know how to vary the velocity of the motor that would help a lot.
thanks

5
G-Code, CAD, and CAM discussions / Re: Help writing G-Code
« on: June 19, 2007, 01:49:07 PM »
thanks for your help that works great.

6
G-Code, CAD, and CAM discussions / Re: Help writing G-Code
« on: June 18, 2007, 02:19:53 PM »
to be honest it does not matter one bit, as of right now I have just been jogging the motor.

7
G-Code, CAD, and CAM discussions / Help writing G-Code
« on: June 18, 2007, 01:53:03 PM »
Hi,
I am currently testing servo amplifiers and servo motors using this mach 2 software. I need to have a program where I can run the motors one direction then back the other direction. This needs to be repeated around 100 times.  If it is two rotations then two rotations the other way and then this would be repeated 100 times would be awesome. I only test one motor a time on the x-axis. I realize this is very simplistic but I am having a lot of trouble sorting through all the G-code tutorials because I need to do something so simple but everything is made for the three axis. If anyone could help me write this that would be a huge help.....

Pages: 1