Hello Guest it is March 28, 2024, 06:09:41 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Crattle91

Pages: 1
1
Mach3 under Vista / Z axis running in reverse
« on: July 26, 2015, 08:41:37 PM »
Need some help if you please. I am attempting to run my first project on Mach 3 and when my router begins to run it slams into my table. (Good thing I have a spoil board) I have narrowed the issue down to the Z axis being programmed in reverse but am unsure how to correct it.
 Help please...

Pages: 1