Hello Guest it is March 29, 2024, 07:49:55 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Garysb56

Pages: 1 2 »
1
Finished Screens / Re: Mach3 2010 Screenset - Now available
« on: May 15, 2019, 01:28:31 PM »
I keep get a massage "to fast for pulley" what is this and why?

2
Finished Screens / Re: Mach3 2010 Screenset - Now available
« on: May 13, 2019, 02:08:33 PM »
Hi I'm having a strange problem where when i move the display screen around my machine stops and i have to cycle start again but am not losing communication i can just cycle start and all is well as long as i don't move the screen around. any ideas ?

3
Finished Screens / Re: Mach3 2010 Screenset - Now available
« on: April 29, 2019, 08:41:09 PM »
I have a problem with my spindle spin up before cut is to short and it crashes my machine . is there a way to increase the wait before spindle spin up .

4
General Mach Discussion / Re: losing communication with UC-100
« on: March 20, 2019, 08:36:02 PM »
 I'm running window 7 64bit I5 CPU and 8gig ram  and i have over 3/4 disk space . i am using a 6" usb cable that came with the uc-100 controller

5
General Mach Discussion / Re: losing communication with UC-100
« on: March 20, 2019, 06:18:55 PM »
im thinking its an FR problem too but have not been able to nail it down... :(

6
General Mach Discussion / Re: losing communication with UC-100
« on: March 20, 2019, 06:16:13 PM »
thank you for the info. I did the same and added a chock and that fix the problem for the most part before i made the change to 2010 now its back ... but haven't tried a shorter usb cable yet...!

7
General Mach Discussion / losing communication with UC-100
« on: March 20, 2019, 04:08:45 PM »
now after installing 2010 i'm losing communication with my cnc . i use to take a error every now and then and the machine would stop , but could just hit start again and the job would go on. now i have to reboot the computer to get going again any Ides?

8
Finished Screens / Re: Mach3 2010 Screenset - Now available
« on: March 20, 2019, 12:28:12 PM »
thank you

9
Finished Screens / Re: Mach3 2010 Screenset - Now available
« on: March 20, 2019, 01:34:01 AM »
hi again Gerry , can you tell me what key is the Z jog ?

10
Finished Screens / Re: Mach3 2010 Screenset - Now available
« on: March 19, 2019, 12:38:37 PM »
Thank you Gerry i had copied it to mill and i'm using Oxzila, up and running can't wait to try out the tough off feature..

I am wondering your thoughts  on the 2017  I beleave it UCCNC ?

Pages: 1 2 »