Hello Guest it is March 29, 2024, 04:07:58 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - mikaelj

Pages: 1
1
HiCON Motion Controller / Re: Motion buffer out of sequence, code 130
« on: July 16, 2015, 08:19:18 PM »
Flashed it with the new FW. 2.59 is a winner.  ;D

 Now I can jog. Will proceed to setup relay and some other inputs again.

Still crashes though...

2
HiCON Motion Controller / Re: Motion buffer out of sequence, code 130
« on: July 16, 2015, 08:11:44 PM »
I currently run this:
HiCON Plugin: 1.08.06, Target_Mach4_Build: 2491, Board: 7766, Serial: 8BBFDD, FW: 2.58, FPGA: 7E7B, IP: 192.168.0.35, AdapterIP: 192.168.0.10

Will try to upgrade to FW 2.59.

Do you think the crash issue is has anything to do with the Integra?

I still get the motion buffer out of sequence error when trying to jog. Any suggestions?

I use RL1 on J11 to ground a contactor (RLC = GND) wich controls my spindle motor. Cant get it to click.

3
HiCON Motion Controller / Re: Motion buffer out of sequence, code 130
« on: July 16, 2015, 07:37:26 PM »
Thank you!

Yes, the problem was bad config - since mach 4 crashes every time I leave the config screen the settings was screwed up.

I have succeeded in moving the motor from the config screen but as soon as I click OK in the config plugin screen mach 4 crashes (the Enable/Disable button flickers and the program freezes).


 

4
HiCON Motion Controller / Motion buffer out of sequence, code 130
« on: July 16, 2015, 07:04:41 PM »
Cant seem to get my Integra 7737 moving or doing anything.

I get the "Motion buffer out of sequence" error when i try to jog and "Cant execute. Code 130" when in motor config screen and clicking execute.

Wont trigger relays either. Where to begin?

Pages: 1