Messages

1

General Mach Discussion / Re: Total Novice who stupidly bought a cnc3020T-DJ thinking she could figure it out!

« on: July 02, 2015, 09:21:04 AM »

Thanks for the replies, I've looked up Vetric but not sure what course name to key in. I have also contacted a local firm that has CNC machines in the hope they can give me a little lesson, they said to pop in so hopefully they can help me. I was hoping that someone on here who also had the same machine could take a photo of their home/soft limit page so I could see how they have it set up to start with if that makes sense! Anyway thanks again

2

General Mach Discussion / Total Novice who stupidly bought a cnc3020T-DJ thinking she could figure it out!

« on: July 01, 2015, 08:17:04 AM »

Can someone PLEASE help me. I run a wedding venue accessories business and have been paying someone else to make small signs for venue's etc at quite a cost to me, so i stupidly thought i could teach myself to use a CNC 3020T-DJ (PLEASE DON'T LAUGH). Anyway i have managed to set it up, i have it moving, but i'm struggling with setting Home/soft limits, i have listened to you tube videos and i don't understand a bloody word, can someone please tell me in English with no fancy jargon so i can prove to my family that maybe i'm not a total idiot after all. Thank you for even bothering to listen to this woman who is just about to throw it out of the window x