1
General Mach Discussion / Re: Cannot control 3040 spindle with M3/M5. Are my settings correct?
« on: June 24, 2015, 05:04:31 PM »
Hi All,
Just joined the Mach 3 Support Group.
I am having the same issue. Anyone solve this? I am in communication with the vendor as well to see if they have a solution (if there is one).
Good News: Received my 3040 CNC with 800W VFD Motor few days ago. I Got X,Y,Z communication with Mach 3 to work.
Bad New: Mach 3 software is not able to turn on/off the spindle or control it. Or even give me a read out on the RPM.
So far I can only control it manually from the inverter. The inverter gives me a Frequency Digital Display (Hz readout though that I can convert to RPM)
Thank you,
Robert
Just joined the Mach 3 Support Group.
I am having the same issue. Anyone solve this? I am in communication with the vendor as well to see if they have a solution (if there is one).
Good News: Received my 3040 CNC with 800W VFD Motor few days ago. I Got X,Y,Z communication with Mach 3 to work.
Bad New: Mach 3 software is not able to turn on/off the spindle or control it. Or even give me a read out on the RPM.
So far I can only control it manually from the inverter. The inverter gives me a Frequency Digital Display (Hz readout though that I can convert to RPM)
Thank you,
Robert