Messages

1

General Mach Discussion / Re: MACH3 Demo

« on: June 27, 2015, 07:49:05 AM »

Thank you everyone. 

Up and running with other software. 

2

General Mach Discussion / Re: MACH3 Demo

« on: June 24, 2015, 10:21:55 AM »

Thank you Nick. 

I'm guessing it's a problem somewhere in the configuration. 
Since I have the UC100 cable, I'm going to try UCCNC software.

3

General Mach Discussion / MACH3 Demo

« on: June 23, 2015, 08:38:41 AM »

Hello,

Should I be able to test MACH3 software (demo) before I purchase ?

Here's my story ...... MACH2 will run my mill, XP only.  I downloaded MACH3 (demo), using a different pc
with Win 7 (no parallel port)  and a UC100 cable. When I start the software I have a choice for what cable to use.
I cannot get no machine response at all meaning, jog or sample program run.
Any help at all will be very much appreciated.

Thank you.

4

General Mach Discussion / Re: Rosequist mill and Mach3

« on: June 06, 2015, 07:29:19 AM »

Hello Syl,

Are you still active here ?
I have the same mill and have problems getting it to respond to the software.
Hope to see your reply.

Thank you.