Hello Guest it is March 28, 2024, 12:32:35 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - L. Banasky

Pages: 1
1
Mach4 General Discussion / Re: Procunier Tapping
« on: July 05, 2016, 08:42:59 AM »
Good morning Bob,
I also think my Mach4 build 4.0.1.2491 is too old to create a 'profile package', I will
update that as well.
Enclosed are 2 files that might help. Remove the .jpg extension
Thanks,
Larry

2
Mach4 General Discussion / Re: Procunier Tapping
« on: July 05, 2016, 05:05:16 AM »
Thanks Gary and Bob,
Gary, I'll look into the subroutine method, but I'm used to just using SheetCam.

Bob, I'll update everything when I get a chance. I will also send the profile package.
The .tap file was in the original post, but was hard to see in between the other 2 files.

Thank you both for your help,
Larry

3
Mach4 General Discussion / Re: Procunier Tapping
« on: July 04, 2016, 09:19:59 AM »
I think that it will work now, I checked a couple of boxes in
Spindle Control, even though I don't have a spindle control
or spindle speed sensor, it seems to work.
Do you think this will cause any problems?
Thanks,
Larry

4
Mach4 General Discussion / Procunier Tapping
« on: July 03, 2016, 12:07:48 PM »
Drilling operation works fine, tapping operation stops on line 18, and if I run from line 19, it stops
again on line 24. No errors reported.
I'm using Mach4 Version 4.0.0.2491
Any suggestions will be greatly appreciated.
Thanks,
Larry

5
Mach4 General Discussion / Re: The great screen debate
« on: August 24, 2015, 12:33:18 PM »
That's because your using Large Fonts, which many people do now on higher res monitors.
The programmers need to account for Large fonts, as they're use is becoming more and more common.
Thank you very much Gerry,
I had no idea that there were so many settings, went to a lower setting and the screens are better.
Thanks again,
Larry

6
Mach4 General Discussion / Re: The great screen debate
« on: August 24, 2015, 08:01:46 AM »
The screens all look good on my desktop,1920 X 1080. The problem is when I use my wife's Toshiba 4K laptop, all the screens are usable except the Mach Configuration Screens for Axis Mapping, Homing Limits etc.
The Mach General and Motor Configuration Screens are good. I tried changing every resolution possible, installed 2651, still no change.

Pages: 1