Hello Guest it is July 23, 2019, 11:09:57 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - uniquelydc

Pages: 1
1
General Mach Discussion / Re: XML file for potential parallel card issue??
« on: February 12, 2016, 08:43:31 AM »
Running the driver test - says system excellent - pulsing between 25281 to 25400

2
General Mach Discussion / XML file for potential parallel card issue??
« on: February 12, 2016, 08:20:47 AM »
Here is my xml file.  Jog seems to work fine - otherwise system starts at 100% then begins to slow to crawl & stops.  PSU voltage seems fine.

3
Checked the power supply unit.  It stays consistent at 48v output through the process.

4
Hey everyone - looking to see if you think my Parallel interface card might be failing.  Running Mach3 - system has been cutting fine.  Today, start a file, starts cutting fine then slowly the X axis, Y axis and even the router start to slow all the way down to a crawl - then stops.

Wondering if this might be the Parallel interface card.  I have checked voltage output of power supply,  If I restart the same file - it starts at 100% then starts to slow down again.

Any ideas????  In-A-Pinch   Peter.

5
Hey, Peter here in Maryland USA.  Got a CNC machine on a 5'x10' table in my shop.  Bought 8 months ago and worked great til computer failed. Reloaded Mach3 - have basic movement now but would really like to hire someone that could come to Gaithersburg MD to tweak and get a few things like Auto Z all up and running.  Please let me know.

6
Hello BAR,

It is a 32bit computer.  Yes, I did download the manual.
The manual doesn't go into the setting of dip switches on the individual motors for each axis.

Peter

7
Hello All,

I am new to this forum and could use some help.  Bought what I believe is a home-made CNC system that had Mach 3 and Aspire in it.  Worked great for 6 months and then the computer died.  Bought a new computer with Windows 7, downloaded Mach 3 and am trying to get it to talk to my CNC.  In the manual, I can't figure out how to get Mach 3 to talk to the motors for the X,Y and Z axis.  I see the dip switches on the motors but am really struggling to get this machine up and running.

I am looking for some help here in Maryland - any direction you might be able to give me would be appreciated.  I am not a CNC guy by trade but was able to have this system do all the cutting work I needed for scenery, sets, props - things like that.  Now I am frustrated that I can't figure it out.

Please shoot me a note - help would be greatly appreciated.   Thanks   Peter

Pages: 1