1
General Mach Discussion / Post Processor!
« on: April 13, 2015, 05:53:48 AM »
Hey guys!
I am using CreoElements to create my 3D models. I started using the same program
for creating G code. When I try to save the code I have to select post Processor.
Does it matter which one I select?
My CNC is an EBAY 3040 milling.
Thanking you in advance!
I am using CreoElements to create my 3D models. I started using the same program
for creating G code. When I try to save the code I have to select post Processor.
Does it matter which one I select?
My CNC is an EBAY 3040 milling.
Thanking you in advance!