Hello Guest it is November 29, 2023, 10:04:49 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Huder

Pages: 1
Modbus / controlling axis via modbus
« on: March 20, 2015, 09:52:17 AM »
I have microcontroller board with modbus RTU and RS485 protocol. And i want to send DIR and STEP signals of X, Y Z, axis from mach3 to my board via modbus.
It is possible?

The speed/latency of this solution is not important.

Pages: 1