1
FAQs / Proxxon FF500 cnc setup for Mach3 help
« on: March 10, 2015, 04:39:23 PM »
I have a 3040 cnc which works great with Mach 3.
I also have a Proxxon FF500 which is extremely accurate but came with NCCAD8, which is an absolute pile of rubbish, to the point of being unusable!
I tried to get Mach3 to run the Proxxon but...nothing!
I have contacted Proxxon but sadly not received any reply
Any ideas chaps?
I also have a Proxxon FF500 which is extremely accurate but came with NCCAD8, which is an absolute pile of rubbish, to the point of being unusable!
I tried to get Mach3 to run the Proxxon but...nothing!
I have contacted Proxxon but sadly not received any reply
Any ideas chaps?