Messages

1

General Mach Discussion / Re: ajusting Z while cutting with xbox controller

« on: March 09, 2015, 10:05:34 AM »

Thats exactly what I was hoping I could do. There are no choices in the drop down menus though. And I'm not sure where else to look.
was hoping someone on here had figured it out. 

2

General Mach Discussion / ajusting Z while cutting with xbox controller

« on: March 08, 2015, 10:03:24 PM »

Is there any possible way to adjust the Z while cutting? I have an oxy fuel setup and I have set the THC up and down to emulate on the keyboard, and it works, but just wondered if it was at all possible to have the xbox controller do it?
Thanks