Hello Guest it is March 29, 2024, 12:50:08 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - opantoja

Pages: 1
1
General Mach Discussion / Re: Wear offsets in the wrong direction
« on: March 04, 2015, 11:21:00 PM »
Thanks Hood. I think I can manage it. As long as I know which direction is moving.

Regards,
Oscar

2
General Mach Discussion / Wear offsets in the wrong direction
« on: March 03, 2015, 11:59:53 PM »
Hi Everyone,

I wonder if someone can help me with the following issue, I just started working on a "MACH3 turn". The problem I currently have, is that every time I make an offset in the wear offset page, the machine takes it in the opposite direction. Is there any switch or parameter that I need to change?

Thanks in advance,
Oscar

Pages: 1