Hello Guest it is March 29, 2024, 11:55:44 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Garry F

Pages: 1
1
Bargain Basement / Re: X2 Minimill cnc'd
« on: November 04, 2015, 05:11:31 PM »
So what part of the country are you in..

Garry
g m fo s t er at g ma il . co m

Thanks

2
Newfangled Mill Wizard / Re: Tabs
« on: July 05, 2015, 12:04:07 AM »
Thanks Ron be watching for the router version.

3
Newfangled Mill Wizard / Tabs
« on: July 04, 2015, 07:18:53 PM »
Is there any easy way to add tabs to Mill Wizard. I use mostly a router and tabs are very handy. I have looked and don't see a way do do this easily.
Garry

4
Mach4 General Discussion / Re: Mach4 / Darwin setup
« on: April 04, 2015, 04:15:00 PM »
You have to set thing up botj on Darwin config and Mach 4 config...
Bit me as well.

5
Mach4 General Discussion / Re: Mach4 Printer Port Discussions
« on: February 28, 2015, 07:00:32 PM »
Another question..

I can't get my Z to work I have it set up as motor 2 I think but get no movement In Mach 4.
In the Darwin config I see no way to test the z axis as only the x and y show up in  the quadrant box. I can move the x and y in all the quadrant boxes of motors 0,1,2.

I must be missing something really obvious I know Art said in one of his videos that he didn't use the z axies as he was using a laser. SO is there a default somewhere getting to me.

Thanks

Never mind found my issue and it was me...

6
Mach4 General Discussion / Re: Mach4 Printer Port Discussions
« on: February 28, 2015, 06:39:10 PM »
Another question..

I can't get my Z to work I have it set up as motor 2 I think but get no movement In Mach 4.
In the Darwin config I see no way to test the z axis as only the x and y show up in  the quadrant box. I can move the x and y in all the quadrant boxes of motors 0,1,2.

I must be missing something really obvious I know Art said in one of his videos that he didn't use the z axies as he was using a laser. SO is there a default somewhere getting to me.

Thanks

7
Mach4 General Discussion / Re: Mach4 Printer Port Discussions
« on: February 28, 2015, 06:08:20 PM »
Thanks for the answer

8
Mach4 General Discussion / Re: Mach4 Printer Port Discussions
« on: February 28, 2015, 05:55:20 PM »
Can both Mack 3 and Mach 4 drivers be in memory at the same time? Thanks

Pages: 1