Hello Guest it is December 02, 2020, 10:29:18 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - dukie94

Pages: 1
General Mach Discussion / Re: Homing/limit switches
« on: May 10, 2016, 09:51:55 PM »
Thank you for responding!!!
I have tested the all connection with the meter many times
and checked for lose wires twice as much.
I think it may be Mach3.
normally in feed rate it should be 100 its 6.00
the Normal condition button is yellow in the past I would hit it
and it would turn green now when I hit it  a little box window
comes up and says
Warning: This will reset your monitoring to consider current conditions
as normal.

General Mach Discussion / Homing/limit switches
« on: May 10, 2016, 02:54:07 PM »
A few weeks ago I turned on my machine hit Ref. home z went up and did not stop. No signal to switches X,Y or Z.
I could still jog all the Axis and also run the machine just could not Ref. Home.
I thought it might be the motion card I have leafboy77 in my machine.
I bought a new board ( mach3 motion card) but had not installed it yet.
Yesterday I turned on the machine hit Ref. Home Z got a signal and so did Y but not X.
Went to home depot came home hit Ref. Home and wow all three switches got a signal.
Thought all was good.
Turned on the machine this morning and no signal on any of the switches.
Is my problem Mach3 or is it the motion card?
Thank you,

G-Code, CAD, and CAM discussions / Mach3 Cam/cad
« on: May 04, 2015, 03:15:53 PM »
I just bought a cnc machine. I need help setting up mach3.
How to convert from vectric to mach3?
Thank you,

General Mach Discussion / Re: new to cad cam more questions
« on: February 06, 2015, 08:24:19 PM »
Does anyone use JDPaint 5.5 or Type 3 with mach3?

Pages: 1