Hello Guest it is March 28, 2024, 02:41:12 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - BigfootQA

Pages: 1
1
I built my own CNC wood router and put limit switches at the end of each axis. I wired the home switches individually and connected to an input pin. I wired other three axis limit switches in series so if one trips it goes to another input pin. I configured Mach 3 with X-- and Home one pin 10 and X++, Y++, and Z++ on pin 13. When machine tries to home it trips the home switch and stops the machine as if the limit is hit. What I want it to do is to activate the home switch and then back off until it's not tripped. Am I missing something in my config?

Thanks

Pages: 1