Hello Guest it is March 29, 2024, 05:52:49 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - scalci

Pages: 1
1
Finished Screens / Re: Mach3 2010 Screenset - Now available
« on: May 23, 2020, 12:36:54 AM »
Hi I bought the 2010 screen set two days back. Have not heard anything since. I sent an email to the address as well....

Where so I download this from?


2
Mach4 General Discussion / Migrate from Mach3 - 4 (XYYZ) CNC
« on: October 02, 2016, 02:40:27 AM »
Hi Everyone

I think it is time to give Mach4 a try again. I did when it came out but had no success.

Are there anyone that have done this successfully to gibe me pointers, or even better is there a way to migrate my Madh3 config to Mach4?

I remember I had a problm to hpget tje Dawin parallel port emulator to,work.....

Rgs
Scalci

Pages: 1