Hello Guest it is March 28, 2024, 04:13:38 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - saab9395

Pages: 1
1
General Mach Discussion / Re: How to swap the x and y axes
« on: February 10, 2015, 03:31:40 AM »
Hi,

i dont see the specs. in motor tuning. can you tell me where they are?

any help

Saab

2
General Mach Discussion / Motors are uncontrolable
« on: January 29, 2015, 08:07:47 AM »
Hi all,

 I have a blue board TB6560 and what it happend is the motors started to turn whenever the board is connected to PC and power source is running. I was not clicking anything.
 Have any solutions how to fix that?

Saab

3
General Mach Discussion / Re: LTP cable overheating problem
« on: January 27, 2015, 12:37:53 PM »
HI guys

i was testing it like you said but it still didnt work. The cable was still heating too much. Do you have any other ideas

thanks

saab

4
General Mach Discussion / Re: LTP cable overheating problem
« on: January 23, 2015, 07:14:57 AM »
Hi

i was wondering when i was reading what do you mean by "shield".

saab

5
General Mach Discussion / Re: LTP cable overheating problem
« on: January 23, 2015, 01:21:51 AM »
Hi

Thanks dude i will try to fix it and i will message you back.

Saab

6
General Mach Discussion / LTP cable overheating problem
« on: January 22, 2015, 01:16:27 PM »
Hi all

so lately i have been doing some tests with mach3 and stepper motors and what i have found is the LTP cable which is connectning the PC and the mother board started to heat up.
Does anybody know why is it heating up and can you tell me how to fix that?

thanks

saab

Pages: 1