Hello Guest it is November 19, 2019, 02:15:59 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - gormbo

Pages: 1
1
General Mach Discussion / Need Help With NC Studio to Mach 3 conversion
« on: January 17, 2015, 07:03:19 PM »
I am new to the world of cnc and have bought a J Cut 25s I want to convert it to run on Mach 3. I have replaced the BOB with a UG08 and UC300 from CNC 4 You to run from a Windows XP Laptop with a usb port. I have the rewiring part finished and installed Mach 3 and the drivers for the UC300 but I can't get the machine to move on any axis. I would really appreciate any help as i have tried everything I can think of ???

Thank you in advance.

Pages: 1