Hello Guest it is September 29, 2020, 05:46:37 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - veit

Pages: 1
1
We have done it like this but the motors are ok, the run fine. We are also checking the electronic part ....

2
Hi thanks for the answer, we checked all this stuffs - we are just working with 15% on the X axis.

3
Hi, we have a old Bridgeport milling machine with a Mach3 control. Since five weeks we have a very heavy problem, I will explain it with the following example: We made a sample rectangular of 2" x 6". The first four cycles the milling machine made them normally, after that she started to move the center on the X axis on the left, after two cycles we have had just a movement of more than 1 mm to the left side. With every cycle she moves center a little bit more to the left. Someone knows this problem and has a solution? Thanks Veit

Pages: 1