Messages

1

General Mach Discussion / freezing issues

« on: January 08, 2015, 12:24:12 AM »

I have been running mach 3 without issues for years.   Lately, I have had freezing up issues.  After trying all sorts of remedies today I switched to a new PC and downloaded Mach 3 on it.  This setup is not freezing, however with all the same pin settings and hotkeys as the last set up,  my axis seem to be all mixed up.  The hotkeys that should control the z axis, controls the Y and so on?    I did not change anything on the BOB or any plugs.
Any ideas?   Strange issue.



thanks