Messages

1

General Mach Discussion / Mach3 Setting Back Up

« on: December 31, 2017, 08:24:08 PM »

What is the best sure fire way to back up Mach3 settings?

2

General Mach Discussion / Re: Need help setting up Mach 3 for my table.

« on: July 09, 2015, 12:30:34 PM »

I purchased a 5 x 5 Lightning CNC Plasma table. After building a special room for the table I am ready to do the setup. I built a water table also. I need to 1st confirm if the software is pirated. If it is I will purchase a legit copy.
The table is setup and leveled.
I am completely new to the Mach 3 software or any CNC software as far as that goes.
I have a Miller Spectrum 875 plasma machine to use on the table. The plasma cutter is not wired into the mach3 board yet.
I would appreciate any and all help I can get from other Mach 3 users.