Hello Guest it is May 26, 2019, 02:19:18 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Eazyt

Pages: 1
1
General Mach Discussion / Re: New to mach3 and cnc/ not cutting in cm
« on: January 05, 2015, 09:49:10 PM »
Well I changed my steps from 640 to 320  and now it cuts perfect mm . But now when I'm cutting  a program  it seems to cut the holes good but then when it's time to cut out the object it starts half way up the material. 

2
General Mach Discussion / Re: New to mach3 and cnc/ not cutting in cm
« on: January 05, 2015, 10:41:50 AM »
Thanks for the reply, when I set up the machine w mach I used the mm , and when I go through mach and look around. The mm button is on.
So according to mach it's in mm.  My Routcad software uses cm . . Not sure what els to try.
Tom

3
General Mach Discussion / New to mach3 and cnc/ not cutting in cm
« on: January 04, 2015, 11:06:43 PM »
I have a 3axis cnc with mach 3  and Routcad software. But every time I draw something in cm in the Routcad then load the gcode in mach3 it starts to cut in a larger  scale.  I've checked everything I know of and it's all showing metric. Any help would be great

Pages: 1