Hello Guest it is November 29, 2021, 01:53:28 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - imajeenyus42

Pages: 1
1
General Mach Discussion / Re: Spontaneous Z axis movement
« on: January 05, 2015, 06:52:50 AM »
Hi,

I feel like an idiot, but I think I found what was the problem (a few hours after posting this topic - there must be some corollary to Murphy's law that says you'll
discover the solution to a problem soon after asking someone else about it). I was going through the screens yet again and noticed that "tangential approach mode"
was active. Not knowing what it was, I had left it alone previously, but this seemed to be causing the effect. The lift distance was set to 1 unit, and when
I disable it, the strange behaviour went away. I think I understand why it's doing it, if the purpose is to realign a cutting knife or similar.

Cheers,

Lindsay

2
General Mach Discussion / Spontaneous Z axis movement
« on: January 04, 2015, 07:58:03 AM »
Hello,

I've recently upgraded from Mach2 to Mach3 and I'm experiencing some strange Z movement when in step jog mode. I'm running a
3-axis gantry router.

When I'm in step jog mode, and I change from stepping one axis to another, or even from positive to negative, the Z axis travels
down exactly one unit, then back up, then the requested axis makes its instructed step! This does not happen in continuous mode, only in step.

Additionally, when the Z is travelling back up, the program line number box displays "2" (see http://imajeenyus.com/temp/mach3_screen.jpg) and then goes back to "0"
once the Z has finished travelling. There is no G-code program loaded, and the program line number is "0" normally.

I've looked through the settings and fiddled with anything that says 1 unit, but nothing seems to have any effect. I'm understandably
wary about using this, so I've gone back to using Mach2 for now, until I sort this out.

Does anyone have any ideas what might be causing this? It's probably some feature I've never used/understood before - I've never worked
with safe heights, tool offsets, coordinate systems etc., just basic G-code and jogging.

Best regards,

Lindsay Wilson

Pages: 1