1
Newfangled Mill Wizard / Re: Gcode on Circle, Arc and feed rate errors
« on: January 04, 2015, 07:04:09 PM »
Hi Ron,
Tks for the feedback; tried again and worked but need to uncheck the "Spiral Z step" if checked feed-rate keeps low; understood very soon will have a new release and hope all this is fixed.; correct ?
Thank you
Tks for the feedback; tried again and worked but need to uncheck the "Spiral Z step" if checked feed-rate keeps low; understood very soon will have a new release and hope all this is fixed.; correct ?
Thank you