Hello Guest it is March 29, 2024, 12:45:25 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Horasio310

Pages: 1 2 3 »
1
SmoothStepper USB / Re: Stepper glitches fwd and rev
« on: October 19, 2016, 12:23:22 AM »
Thanks for your help problem solved, I had enabled backlash compensation on the z axis on a lathe and I took me sometime before realizing this I swapped out the z axis with x axis drive and it keep doing it then I used the axis to move the z motor and it stopped doing this, so I started going through all my settings and backlash was enabled for z axis .. Disabled and it is working great ...

Thanks

2
SmoothStepper USB / Stepper glitches fwd and rev
« on: October 18, 2016, 12:08:20 PM »
I'm having a little problem, 570oz nema 23 motors with digital drives and a ess board..

If I send increments of .0005 moving toward one direction I get exactly that but when I try sending it back in the same .0005 increments the stepper goes fwd still one or two steps and then goes the correct direction..

Tell it to go fwd goes fwd tell it to go rev and goes fwd then goes reverse ?

Any idea why this could be happening possibly tuning the motors some ?

I'm going to try another drive today and check the pulse from the ess to see if it is sending mixed pulses maybe ? 



Thanks, Horasio

3
CS-Lab / Re: Sanyo Denki Spindle Motor/ Drive
« on: June 26, 2016, 05:16:54 PM »
Meant Fanuc Model 6 ac spindle motor  and doing a shot pin to orientate spindle

4
CS-Lab / Re: Sanyo Denki Spindle Motor/ Drive
« on: June 26, 2016, 05:15:11 PM »
I'm thinking what to do because I'm very limited to space on the head because of the mechanical tool release mechanism.. I'm thinking sourcing a Fanuc model y ac spindle motor and a vfd ? What do you guys think

5
CS-Lab / Re: Sanyo Denki Spindle Motor/ Drive
« on: June 24, 2016, 05:57:07 PM »
So if I want to go vfd route I'd need to get for example a fanuc ac spindle motor and run that off a vfd drive ?

6
CS-Lab / Re: Sanyo Denki Spindle Motor/ Drive
« on: June 24, 2016, 04:26:38 PM »
I've seen fanuc spindle motors being used with vfd drives would this be similar ?

7
CS-Lab / Re: Sanyo Denki Spindle Motor/ Drive
« on: June 21, 2016, 05:42:22 PM »
Maybe one of those Speedstar vfd's that are 10hp ?

8
CS-Lab / Re: Csmio-ip/s
« on: June 21, 2016, 01:54:39 PM »
I'll look into that thank you

9
CS-Lab / Re: Sanyo Denki Spindle Motor/ Drive
« on: June 21, 2016, 10:11:35 AM »
It is a 7.5 kW 10hp

10
CS-Lab / Csmio-ip/s
« on: June 20, 2016, 02:38:29 PM »
I installed the Ethernet cable and 24v to it and plugged it to my pc but no go does it need to be fully wired before setting ports and pin configured ?

Thanks,
Horasio

Pages: 1 2 3 »