Hello Guest it is March 28, 2024, 06:08:30 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - tbowen

Pages: 1
1
General Mach Discussion / Re: Feed rate changing
« on: December 03, 2014, 02:16:56 PM »
Um, kinda like, nevermind.  It was my fault.

This was a very simple program, maybe 30 lines or so, so I figured I'd just Notepad it by hand and not bother with the CAM software.  The code was mostly right, it's just that I kinda forgot that I needed line numbers.  So I guess Mach3 read the whole thing in as one long command.  The last feedrate in the program was 7.5, so that's what it used.  Crap.

2
General Mach Discussion / Feed rate changing
« on: December 03, 2014, 01:20:37 PM »
If I click Stop or Reset while my g-code is running, the feed rate changes to 7.5 and stays there until it hits another feedrate change command in the code.  Any ideas? xml attached.

Pages: 1