Messages

1

General Mach Discussion / Using a proximity sensor as a tool height setter...

« on: April 02, 2015, 10:02:29 PM »

I'm thinking about using a npn proximity sensor to set my tool height.

I'm using a 1.5kw spindle on a cnc router table and the tool is not grounded.

Has anyone successively done this?

Thx.

2

Brains Development / Re: Can a brain trigger a wave file?

« on: March 30, 2015, 07:53:03 PM »

Thanks,

I'll have to play around and see what I can come up with.

3

Brains Development / Can a brain trigger a wave file?

« on: March 30, 2015, 04:07:58 PM »

I'm able to trigger a output to operate a physical (powered) buzzer/alarm using a brain.

However, I would like to have a wav file (audio alarm) play when I push the e-stop button or any action for that matter.

-Tom

4

VB and the development of wizards / Re: Need help modifying M6 to output to a relay to activate a tool change buzzer.

« on: March 28, 2015, 05:57:26 PM »

Thanks Nick,

I'll play around with Brains.

Once again... thanks for your time!

-Tom

5

VB and the development of wizards / Re: Need help modifying M6 to output to a relay to activate a tool change buzzer.

« on: March 28, 2015, 10:21:37 AM »

Bodini,

Good to hear there's a way to do it. However, I'm not familiar with dealing with Brains. Could you clue me in on how to do this?

A sample of a Brain will help me figure this out.

Thx

6

VB and the development of wizards / Need help modifying M6 to output to a relay to activate a tool change buzzer.

« on: March 28, 2015, 12:25:16 AM »

I would like to have an alarm sound when a manual tool change is required.

Any help on how to go about this would be greatly appreciated.


Thx!!

7

General Mach Discussion / Re: I'm having a problem with OEM-code 321 (Run Newfangled Wizard) in machturn.

« on: December 10, 2014, 12:58:12 PM »

Wow......... Thanks Gerry.

LoadWizard("NFSturn")

That did the trick.


Thanks for your help!!

8

General Mach Discussion / Re: I'm having a problem with OEM-code 321 (Run Newfangled Wizard) in machturn.

« on: December 10, 2014, 12:49:32 PM »

Thanks Gerry,

I'll give that a try.

9

General Mach Discussion / I'm having a problem with OEM-code 321 (Run Newfangled Wizard) in machturn.

« on: December 10, 2014, 11:13:02 AM »

I want to add a button to my screen set to pull up and run the Newfangled Turn Wizard. I have an OEM-code 230 (Display Wizard selection window) on my screen which does open the wizard selection window. However, went I press my OEM-code 321 button it doen't do anything.

It seem like 321 should open the wizard and run it.

Thx Mav

10

General Mach Discussion / Re: MachTurn G31 problem

« on: December 05, 2014, 12:24:55 PM »

Eric,

I've install your addon and I'll give it a try after I go through the pdf.

From what I can see (without trying it out), I looks like you have spent some time on it...

Looks Good!

Mav