Hello Guest it is March 29, 2024, 12:02:38 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - kjwalters

Pages: 1
1
Hi KJ,

Welcome to the forum.

Not really sure why you are having the problem.

Your Mach3 license should be named   Mach1Lic.dat  and this is copied into the Mach3 folder. When Mach3 is restarted it should then show your name as Licensed To:

Tweakie.

I dont get either. I dropped the entire unzipped folder into the directory, I would think that would do it. Maybe one of the Mach guys can help I hear their support is good.

2
Hello everyone, my name is Jamie. I am new here and new to cnc. I have been playing around for a year or two but still have allot to learn. Right now I need help which is what brings me here. I am not sure if this is the place to post my question but I will give it a try.
I had a motion control system built for my machine and when I got it had a trial version of Mach 3 that the builder uses to set up the system. I recently (last week) bought my full license of Mach 3  directly from ArtSoft. Anyway, I put the license in the mach 3 directory but when I open mach it still says it's registered to someone name Todd something or other. It does not seem to recognize the new license. Any ideas on how to fix this?

Thanks in advance, it takes people willing to help to get anything done.

Pages: 1