1
General Mach Discussion / Re: Newbie MDI, Calibration, DRO problems.
« on: December 03, 2014, 02:26:08 AM »
Thank you for the reply C30232.
I suspected it might be computer after a fresh XP and drivers install didn't affect the problems.
To verify my suspicions I installed mach3 and the motion controller drivers on a different computer running win7. The problems remain unaffected even on a different computer.
I don't believe two computers running different operating systems could be at fault when both computers display identical problems. That's what has me stumped and why i posted on this awesome community looking for some help.
I'm now looking at the motion controller or motor drives causing some kind of feed back. Since these are the only common I haven't looked at in detail. If the drives or motion controller prove to be the root cause of the computer problems. I suspect the cause of the failure could be from high frequency feed back from my syncrowave 350 tig welder. If I remember correctly the problems with the CNC system developed around the same time I had a small tig welding job to do. I'm not sure if or how this kind of feed back would affect a CNC system.
I suspected it might be computer after a fresh XP and drivers install didn't affect the problems.
To verify my suspicions I installed mach3 and the motion controller drivers on a different computer running win7. The problems remain unaffected even on a different computer.
I don't believe two computers running different operating systems could be at fault when both computers display identical problems. That's what has me stumped and why i posted on this awesome community looking for some help.
I'm now looking at the motion controller or motor drives causing some kind of feed back. Since these are the only common I haven't looked at in detail. If the drives or motion controller prove to be the root cause of the computer problems. I suspect the cause of the failure could be from high frequency feed back from my syncrowave 350 tig welder. If I remember correctly the problems with the CNC system developed around the same time I had a small tig welding job to do. I'm not sure if or how this kind of feed back would affect a CNC system.