1
General Mach Discussion / using inputs to run code
« on: November 11, 2014, 12:55:06 AM »
hi guys,
I'm kind of new to this so sorry if I'm not clear,
I have a machine set up with two working stations, and i would like to have two different gcodes run on the the different stations,
I need a to write a code that will choose what part of the g-code to run based on operator input,
in simple words, I have "input1" and "input2" and depending on witch one is active I want the machine to run a specific part of my gcode.
I would prefer not to use vb since I have run into quite a bit of problems while using vb.
thank you all for your help.
I'm kind of new to this so sorry if I'm not clear,
I have a machine set up with two working stations, and i would like to have two different gcodes run on the the different stations,
I need a to write a code that will choose what part of the g-code to run based on operator input,
in simple words, I have "input1" and "input2" and depending on witch one is active I want the machine to run a specific part of my gcode.
I would prefer not to use vb since I have run into quite a bit of problems while using vb.
thank you all for your help.