1
General Mach Discussion / Re: Newbie here: need adivce on postprocessors compatible with mach3
« on: December 04, 2014, 06:18:41 PM »
Thanks for your answer tweakie. Could you please elaborate how this workaround works and what problem it avoids?
I found in the manual that instead of G2 or G3 the curves must be programmed as a set of G1 moves and in another thread I dug up the solved the problem by converting the g2 or g3 moves into g1 lines. Basically they interpolated the curve with a lot of short lines. How can i do that myself and how does your solution differ from that?
As for the tangential mode it seems i only need to set up the A axis as a rotary axis and activate tangential mode.
I found in the manual that instead of G2 or G3 the curves must be programmed as a set of G1 moves and in another thread I dug up the solved the problem by converting the g2 or g3 moves into g1 lines. Basically they interpolated the curve with a lot of short lines. How can i do that myself and how does your solution differ from that?
As for the tangential mode it seems i only need to set up the A axis as a rotary axis and activate tangential mode.