Messages

1

Finished Screens / Re: Mach3 2010 Screenset - Now available

« on: December 18, 2014, 04:59:08 AM »

I'm new to CNC and I just installed your 2010 screen set.  When I set my soft limits on Z, how do I calculate the min. max. throw?  Do I put a bit into the router and touch off to the bed or a piece of material?  I'm really confused about figuring these numbers.

2

FAQs / Re: Mach3 Loses REF ALL

« on: December 17, 2014, 05:34:31 PM »

Thank you.  I will do that in the morning.

3

FAQs / Mach3 Loses REF ALL

« on: December 17, 2014, 05:17:58 PM »

When I Ref All (X and Y) to the lower left corner and Z to it's highest point, Mach3 loses this setting after restart.  Am I doing something wrong or is there a SAVE command I'm missing.  At present, I have no home or limit switches activated.

Jeri:  I'm new to CNC and I just installed your 2010 screen set.  When I set my soft limits on Z, how do I calculate the min. max. throw?  Do I put a bit into the router and touch off to the bed or a piece of material?  I'm really confused about figuring these numbers.