Hello Guest it is October 01, 2020, 05:29:35 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - chuckels

Pages: 1 2 3 4 5 6 »
1
General Mach Discussion / Re: Mach 3 Feed Rate very slow
« on: April 24, 2014, 08:26:10 PM »
there are other programs that will make M3 act that way .. firefox is one . if I have it  loaded with M3 the feed is very very slow.
make sure nothing else is running in the background. I have heard of other prgms that don't play well with M3 either. quicktime hides in the background and causes issues too.
Chuck Smalfus


2
Mach4 General Discussion / Re: Comments about Mach4 in Demo
« on: April 24, 2014, 08:15:48 PM »
nice work guys. :o
any way to pan on the tool path screen after you zoom?
also can you show the tool path extents  on the tp page, I guess that's possible to do with the editor?


3
General Mach Discussion / Re: home offsets
« on: January 27, 2009, 04:01:24 PM »
thanks Hood.
what E-stop............did you just gasp....LOL

thats actually what I ended up doing but I remember using something different in the past...oh well just a mind fart I guess.

4
General Mach Discussion / home offsets
« on: January 27, 2009, 03:21:53 PM »
is there a way to have the table of the mill automatically go to a set position after homing.
I would swear the home offsets in the homing and limits did that in some older versions.
thanks,
Chuck

5
Newfangled Solutions Mach3 Wizards / Re: Rectangle do a oval?
« on: January 06, 2009, 02:50:41 PM »
Troy,
would it be practical to do a rectangle than a circle over it? or a circle than a rectangle to square the sides?
Chuck

6
Newfangled Solutions Mach3 Wizards / Re: Rectangle do a oval?
« on: January 06, 2009, 02:25:38 PM »
actually if you check out the electrical wizard the duplex outlet cover hole is exactly that shape.
chuck

7
Competitions / Re: ******Guess and win a G100 Grex******
« on: May 22, 2007, 11:06:00 AM »
2,345,678

8
General Mach Discussion / Re: error
« on: April 29, 2007, 09:12:46 PM »
it means your G code is asking for a higher spindle speed than is set in your "config -- spindle pulleys" setting.
if your not using spindle control set this number to any high number -- maybe 20000
chuck"

9
General Mach Discussion / Re: Bobcad 2007 posts and other novelties
« on: April 26, 2007, 02:11:05 PM »
this is the post from BobCadCam V20 try it and let me know if it works.
Chuck

10
General Mach Discussion / Re: Retiring.
« on: April 23, 2007, 01:25:05 AM »
Benny,
Thanks for your great contribution to the CNC community.
Chuck

Pages: 1 2 3 4 5 6 »