Hello Guest it is March 29, 2024, 03:29:13 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jimcav

Pages: 1
1
General Mach Discussion / newbie
« on: September 11, 2014, 06:55:32 PM »
need to under stand a few things I been looking at Mach 2 and 3 software, i think that i need an LPT port on computer? Is the LPT port where the pulse and direction signal come from to drive the stepper driver? can someone please direct me to a good site for beginers.

Jim Cav

Pages: 1